Little Bag Buddy
Vol. 07 · August 2026 · Booklet · v0.1.0

Edge of the Field

What comes after the laminate.

Little Bag Buddy Vol. VII - Edge of the Field cover: four construction-class cross-section stacks in a field-guide layout
Little Bag Buddy Vol. VII - Edge of the Field back cover: fusion-bonded mono-material cutaway with ghosted PU-bonded stack showing absent adhesive

The post-adhesive edge of bag construction: ALUULA Graflyte and Durlyte, Pioneer 10XD, Challenge UltraStretch, and a cautious look at what comes next.

Table of Contents

Open a chapter on its own page.

  1. № 01

    The Adhesive Was Always the Component

    Every laminate spec sheet documents the layers and omits the glue holding them together.

     1 min
  2. № 02

    ALUULA Graflyte and the Mono-Material Composite

    A fusion-bonded polyethylene composite that removes the adhesive, on a short field-data record.

     7 min
  3. № 03

    Single-Layer Hybrids - UHMWPE Without the Laminate

    UHMWPE woven into a single layer: no film, no adhesive, and no fabric-level waterproofing.

     5 min
  4. № 04

    What Comes Next (And the Caveats)

    A hedged 2030 read on bio-derived feedstock, closed-loop recycling, and what stays unpredictable.

     5 min
  5. № 05

    Quick Reference - The Four Construction Classes

    Four bonding mechanisms, four failure modes, and what each one is available in today.

     1 min
  6. № 06

    References

    Sources, primaries, and rabbit holes.

     2 min